Osburn 1000 Installation Instructions

Osburn 1000 Installation Instructions

Combined fan
Hide thumbs Also See for 1000:

Advertisement

Quick Links

COMBINED FAN INSTALLATION INSTRUCTIONS

COMBINED INSTRUCTIONS

1. Do not operate the fan or plug it in without the fan being permanently installed on the stove (fire).
2. When the fan is in place, the electrical cord should be routed as close to the floor as possible and outside
the hearth, away from the unit and wall clearances. Route the electrical cord away from the unit to prevent
damage to the cord insulation. Plug into a standard three prong 110-volt outlet or a 240-volt outlet for use
in Australia.
3. Make sure that the fire in the stove is out, and it has cooled down to room temperature before any
maintenance.
4. Follow normal instructions to continue burning.
OSBURN 1000
1.
Install the two formed mounting plates onto the fan housing as shown in figure 1 and fasten with the four
provided screws (a) through the holes as indicated.
2.
Remove the two bottom heat shield screws (b) and locate the fan and mounting plate assembly between
the inside of the heat shield and the two heat shield spacers as shown in figure 2.
3.
Replace the heat shield screws through the heat shield holes, the mounting bracket slots and into the
spacers to secure the assembly.

OSBURN 1100

1.
Install the two formed mounting plates onto the fan housing as shown in figure 3 and fasten with the four
provided screws through the holes as indicated.
2.
Align the holes of the mounting plate with the holes on the outside of the heat shield and fasten with the
two provided screws as shown in figure 4.
3.
For insert applications, turn the fan switch to the high speed position before installation.

OSBURN 1600

1.
Install the two formed mounting plates onto the fan housing as shown in figure 1 and fasten with the four
provided screws (a) through the holes as indicated.
2.
Align the holes of the mounting plate with the holes on the outside of the heat shield and fasten with the
two provided screws as shown in figure 5 and 6.
FABRIQUÉ AVEC FIERTÉ AU CANADA / PROUDLY MADE IN CANADA
FOR OSBURN MODELS
1000, 1100 & 1600 WOODSTOVES
45105A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 1000 and is the answer not in the manual?

Questions and answers

Summary of Contents for Osburn 1000

  • Page 1 COMBINED FAN INSTALLATION INSTRUCTIONS FOR OSBURN MODELS 1000, 1100 & 1600 WOODSTOVES COMBINED INSTRUCTIONS 1. Do not operate the fan or plug it in without the fan being permanently installed on the stove (fire). 2. When the fan is in place, the electrical cord should be routed as close to the floor as possible and outside the hearth, away from the unit and wall clearances.
  • Page 2 OPERATION FAN CONTROL NORTH AMERICA The fan control is variable speed (rheostat). AUSTRALIE The fan control is an « ON / OFF » switch. MAINTENANCE & CARE Clean the fan air inlet screen regularly. The fan should be kept clean and dust free. Life of the fan will be shortened if operated in a dust filled environment or if restricting air supply overheats the fan.
  • Page 3 Figure 1 Figure 2 45105A FABRIQUÉ AVEC FIERTÉ AU CANADA / PROUDLY MADE IN CANADA...
  • Page 4 Figure 3 Figure 4 45105A FABRIQUÉ AVEC FIERTÉ AU CANADA / PROUDLY MADE IN CANADA...
  • Page 5 Figure 5 Figure 6 45105A FABRIQUÉ AVEC FIERTÉ AU CANADA / PROUDLY MADE IN CANADA...

This manual is also suitable for:

11001600

Table of Contents