Moving The Appliance; Long Rinsing Program; Electrical Or Electronic Product At End Of Service Life; Troubleshooting, Corrective Actions - Krups EA80 series User Manual

KR_ESPRESSO_EA80_EE_OA21003_Mise en page 1 09/12/13 13:58 Page8
If there is not enough water in the water tank, you will be warned by the
Add the appropriate amount of water to the tank and scale removal will continue automatically.
If a power failure occurs during the cycle, you will have to start it up again from the start.
Be sure to complete the entire scale removal cycle to avoid any risk of intoxication.
The scale removal cycle is a continuous cycle. Do not put your hands under the coffee outlets during the cycle.

Long rinsing program

When it is necessary to make a long rinsing program, the appliance warns you of this by flashing the 'clean' and 'calc'
lights.
Remove, fill and replace the water tank.
Under the coffee outlets and steam nozzle place a recipient that can contain at least 0.15 L.
Launch the long rinse program by pressing on the "Service" button.
When the long rinsing program is complete, the "clean" and "calc" lights turn off.
Keep the packing and use it again to move the appliance.
If the unpacked appliance is dropped, it is advisable to have it inspected by an authorised Service Dealer.

ELECTRICAL OR ELECTRONIC PRODUCT AT END OF SERVICE LIFE

Let's all help protect the environment!
Your appliance contains many recyclable materials that can be re-used.
Take it to a civic waste collection point.

TROUBLESHOOTING, CORRECTIVE ACTIONS

The appliance does not turn on
after I press the
Water or steam are coming out of
the steam nozzle unexpectedly.
The espresso or coffee is not hot
enough.
The coffee is too weak or not strong
enough.
he coffee flows too slowly.
The coffee is not creamy enough.
The machine has not produced any
coffee
You used ground coffee instead of
coffee beans.
The grinder is making an unusual
noise.
8

MOVING THE APPLIANCE

Check that the power supply cord plug is correctly inserted in the socket.
button.
If used often, some drops of water may run out of the steam nozzle.
Change the coffee temperature setting.
Heat the cups by rinsing them under hot water.
Check that the coffee bean compartment contains coffee and that it is running
through properly.
Avoid using oily, caramelised or flavoured coffee beans.
Reduce the volume you have selected using the knob.
Select the
Turn the fineness of grind button to the left to obtain a finer grind.
Make your coffee in two separate cycles by using the 2 cup function.
Turn the fineness of grind button to the right to obtain a coarser grind (may depend
on the kind of coffee being used).
Carry out one or more rinsing cycles.
Turn the grinding fineness knob towards the left for a finer grind (may depend on
the type of coffee used).
Change the Claris Aqua Filter System cartridge (follow the installation procedure
on page 13).
Carry out one or two rinsing cycles.
An incident has been detected during the coffee making process.
The machine automatically re-initialises and is ready for a new cycle.
Use your vacuum cleaner to remove the ground coffee in the coffee bean contai-
ner.
There is a foreign body in the grinder.
Contact the Krups Consumer Service.
light.
button.