Operation; Bevel Cutting; Dust Cover - Makita 4326 Instruction Manual

Hex wrench storage
008085
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Adjusting roller (For models 4326/4327)
2
1
008154
Loosen the bolt on the back of the base with the hex
wrench. Move the retainer so that the roller contacts the
blade lightly. Then tighten the bolt to secure the base
and the retainer.
NOTE:
Occasionally lubricate the roller.
•

Dust cover

1
008086
CAUTION:
Always wear safety goggles even when operating
•
the tool with the dust cover lowered.
Lower the dust cover to prevent chips from flying.
However, when making bevel cuts, raise it all the way.
1. Hook
1
2. Hex wrench
2
1. Blade
3
2. Roller
4
3. Retainer
4. Hex wrench
5
5. Bolt
6. Base
6
1. Dust cover

OPERATION

CAUTION:
Always hold the base flush with the workpiece.
•
Failure to do so may cause blade breakage,
resulting in a serious injury.
Advance the tool very slowly when cutting curves
•
or scrolling. Forcing the tool may cause a slanted
cutting surface and blade breakage.
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest the
base flat on the workpiece and gently move the tool
forward along the previously marked cutting line.
1
008087

Bevel cutting

008088
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before tilting the base.
Raise the dust cover all the way before making
•
bevel cuts.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the cross-shaped slot in the base.
7
1. Cutting line
2. Base
2