Makita 4326 Instruction Manual
Hide thumbs
Also See for 4326:
- User manual ,
- Instruction manual (76 pages) ,
- Technical information (7 pages)
Related Manuals for Makita 4326
Summary of Contents for Makita 4326
- Page 1 INSTRUCTION MANUAL Jig Saw 4326 4327 4328 4329 008081 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
EC-DECLARATION OF CONFORMITY ENE019-1 Intended use Model; 4326, 4327, 4328, 4329 The tool is intended for the sawing of wood, plastic and We declare under our sole responsibility that this metal materials. As a result of the extensive accessory... -
Page 3: General Safety Rules
Makita International Europe Ltd. protection. Safety equipment such as dust mask, Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 non-skid safety shoes, hard hat, or hearing 8JD, ENGLAND protection used for appropriate conditions will GEA001-3 reduce personal injuries. Avoid accidental starting. Ensure the switch is GENERAL SAFETY RULES in the off-position before plugging in. -
Page 4: Specific Safety Rules
22. Use the power tool, accessories and tool bits extremely hot and could burn your skin. etc. in accordance with these instructions and 13. Do operate tool no-load in the manner intended for the particular type unnecessarily. of power tool, taking into account the working 14. - Page 5 dial. Higher speed is obtained when the dial is turned in Applications Position Cutting action the direction of number 6; lower speed is obtained when it is turned in the direction of number 1. For cutting mild steel, stainless steel and plastics. Refer to the table to select the proper speed for the Straight line cutting action...
-
Page 6: Dust Cover
008085 1. Cutting line 2. Base When not in use, store the hex wrench as shown in the figure to keep it from being lost. Adjusting roller (For models 4326/4327) 1. Blade 2. Roller 3. Retainer 4. Hex wrench 008087 5. -
Page 7: Bevel Cutting
Bevel cutting Front flush cuts 1. Hex wrench 2. Bolt 3. Base 008088 008091 Loosen the bolt on the back of the base with the hex CAUTION: wrench and slide the base all the way back. Then tighten Always be sure that the tool is switched off and •... -
Page 8: Metal Cutting
4. Guide facing Clean cutting operations performed connecting this tool to a Makita vacuum cleaner. Insert the hose of the vacuum cleaner into the hole at the rear 002776 of the tool. Lower the dust cover before operation. NOTE: 1. Bolt... - Page 9 Circular cuts NOTE: Always use blades No. B-17, B-18, B-26 or B-27 1. Treaded knob Steel base type • 2. Guide facing when cutting circles or arcs. 3. Rip fence Anti-splintering device for steel base (Guide rule) (optional accessory) 4. Pin 1.
-
Page 10: Maintenance
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Jig saw blades • Hex wrench 3 • Rip fence (guide rule) set •... - Page 12 Makita Corporation Anjo, Aichi, Japan 884727-224...