Table of Contents
Advertisement
Installing the outer and inner
sleeves
Place the inner sleeve with the pin facing upward.
Attach the outer sleeve to the inner sleeve securely
while pressing the pin of the inner sleeve.
Fig.9
► 1 . Outer sleeve 2. Pin 3. Inner sleeve
Insert the outer and inner sleeves into the tool while
rotating the inner sleeve clockwise and counterclock-
wise until the outer sleeve touches the tool. Tighten the
two screws firmly.
Fig.10
► 1 . Outer sleeve 2. Screw
NOTICE:
Make sure that there is no gap between
the outer sleeve and the tool.
1
2
3
1
2
OPERATION
CAUTION:
Keep the bolt tips off of the
ground, floor, walkways, etc. to prevent injury
from tripping or falling.
1.
Tighten bolts preliminarily by using a hand wrench.
2.
Hold the tool firmly and place the inner sleeve over
the bolt so that the inner sleeve completely covers the
bolt tip.
Fig.11
► 1 . Inner sleeve 2. Bolt tip
NOTICE:
Be careful when fitting the sleeve onto
the bolt tip. Striking the tip can damage it so that it
will no longer fit inside the sleeve properly.
3.
Push the tool lightly until the outer sleeve com-
pletely hold the nut. If the outer sleeve fails to hold the
nut, rotate the tool clockwise or counterclockwise while
pushing the tool lightly.
4.
Pull the switch trigger. Then the outer sleeve
rotates to tighten the nut.
Fig.12
► 1 . Outer sleeve 2. Nut
NOTICE:
Do not force the tool down excessively.
Apply the downward force to the degree needed
to stabilize the tool.
9 ENGLISH
1
2
1
2
Advertisement
Table of Contents
