Pppoe (Dsl) - D-Link DIR-840 User Manual

Section 3 - Setup
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username and password.
This option is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The software is no longer needed and
will not work through a router.
My Internet Select PPPoE.(Username/Password) from the drop-down
Connection Is: menu.
Auto-Backup: Check the box to enable a backup connection.
Internet Host:
If you enabled Auto-Backup, enter the IP address of the
backup connection.
Address Mode: Select Static. IP if your ISP assigned you the IP address,
subnet mask, gateway, and DNS server addresses. In most
cases, select Dynamic.IP.
IP Address: Enter the IP address (Static PPPoE only).
User Name: Enter your PPPoE user name.
Password: Enter your PPPoE password and then retype the password
in the next box.
Service Name:
Enter the ISP service name (optional).
Reconnect Select either Always-on, On-Demand, or Manual.
Mode:
Maximum Idle Enter a maximum idle time during which the Internet
Time:
connection is maintained during inactivity. To disable this
feature, enable Auto-reconnect.
D-Link DIR-840 User Manual

PPPoE (DSL)

23