Pppoe (Dsl) - D-Link DIR-605 Manual

Section 3 - Configuration
you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE
software from your computer. The software is no longer needed and will not work through a router.
My Internet
Select PPPoE (Username/Password) from the drop-down
Connection:
menu.
Address Mode:
Select Static if your ISP assigned you the IP address,
subnet mask, gateway, and DNS server addresses. In most
cases, select Dynamic.
Enter the IP address (Static PPPoE only).
IP Address:
Enter your PPPoE user name.
User Name:
Enter your PPPoE password and then retype the password
Password:
in the next box.
Enter the ISP Service Name (optional).
Service Name:
Select either Always-on, On-Demand, or Manual.
Reconnection Mode:
Enter a maximum idle time during which the Internet
connection is maintained during inactivity. To disable
Maximum Idle Time:
this feature, enable Auto-reconnect.
Enter the Primary and Secondary DNS Server Addresses (Static PPPoE only).
DNS Addresses:
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1492 is the default
MTU:
MTU.
The default MAC Address is set to the Internet port's physical interface MAC address on the Broadband Router. It is not recommended
MAC Address:
replace the Internet port's MAC address with the MAC address of your Ethernet card.
D-Link DIR-605 User Manual

PPPoE (DSL)

button to
21