Removing A Convection Fan Motor - Thermador CJ302B Service Manual

CJ Oven Service Manual

REMOVING A CONVECTION FAN MOTOR

WARNING
Turn off the electrical power circuit to the
oven at the main junction box before ser-
vicing this unit.
CAUTION
When you work on the oven, be careful
when handling the sheet metal parts. There
are sharp edges present and you can cut
yourself if you are not careful.
Refer to illustration for the following steps.
1. Turn off the electrical power to the oven.
2. To make servicing easier, remove the oven
door (see Page 94).
3. Remove the racks from the oven.
4. Remove the front screws from the left and
right oven rack supports and remove the
supports from the oven liner.
5. Remove the screws from the convection
baffle and remove the baffle from the back
of the oven liner.
6. Remove the hex nut from the front of the
convection blade. NOTE: The nut has left-
rotating threads.
TECH
TIP!!
The convection blade hex nut has left-rotat-
ing threads.
7. Remove the flat washer and e-ring from
the convection blade and remove the
blade from the motor shaft.
8. Remove the screws from the pan and re-
move the pan.
9. Remove the motor screws from the
bracket and remove the motor from the
bracket.
10. Disconnect the two wires from the fan
motor terminals.
11. Connect the brown wire (#45) to the right
terminal of the new convection fan mo-
tor, and the white wire (#44) to the left ter-
minal, then install the motor assembly.
12. Reassemble the oven.
Page 94
Lit. No. 94-30-007A