Software Update / Re-Initializing; Sw Update; Preparing The Hardware - Studer OnAir 500 Operating Instructions Manual

11

SOFTWARE UPDATE / RE-INITIALIZING

11.1 SW Update

11.1.1

Preparing the Hardware

1 2
3
Date printed: 30.07.04
Before you start you will need the following:
• The file containing the new software file on your PC. This will be a file
with an "*.abs" extension. Depending on from where you have got the
software, it also may be in "*.zip" format, in which case make sure you
extract the "*.abs" file before attempting to download to the console.
Copy the "*.abs" file into a known directory on your PC, such as
"C:\OA500 Software".
• A cable to connect the PC to the console. This is a standard PC RS232
serial port extension cable, i.e. 9-pin D-type, male to female. This cable
should be readily available from most computer accessories outlets.
• If you have a Mac, you will also have to obtain a 9-pin D-type to 8-pin
mini-DIN adapter for use with a PC serial cable.
Note: For software updates, please contact your local Studer distributor.
Switch the PC and the console off and connect them using the serial cable.
Use the connector labeled RS 232 on the rear of the console (see below) and
one of the COM port connections on the PC (in the following example, it is
assumed that you use the COM 2 port).
1 2 1 2
3 3
1 2
3
2 1
3
OnAir 500 Digital Mixing Console
SW Update 11-1
2
3
2
3