Installing The Battery - Raleigh Pedelec Impulse Original Manual

stage is in progress, the corresponding LED flashes.
If this stage has been fully charged, the LED will light
up permanently. Now the next LED will begin to flash.
After all five LEDs have gone out, the battery is fully
charged.
b) Seat tube battery: The charging process begins.
The LED of the charger lights up in green. The battery
LEDs light up one by one to indicate the progress of
the charging operation. The battery is charged in five
stages. When charging of one stage is in progress, the
corresponding LED flashes. If this stage has been fully
charged, the LED will light up permanently. Now the
next LED will begin to flash. After all five LEDs have
gone out, the battery is fully charged.
If your charger has an LED, it may be that this
flashes red permanently. If this is the case, a
charging fault has occurred. Have the charger and
battery checked by your specialist cycle shop.
4. Pull the charger plug out of the socket once the charg-
ing operation is complete.
Damaged batteries may not be charged, and fur-
ther use is not permitted.
The battery may heat up during charging. A maxi-
mum temperature of 45°C may be reached. If the
battery becomes any warmer than this, suspend
the charging process immediately.
There is no memory effect. You can therefore fully
recharge your battery after every trip so you are
always ready for the off.
Ideally you should charge the battery at a temper-
ature of between +10°C and +30°C. It takes longer
to charge the battery at low temperatures, while
the battery will not charge up at temperatures
higher than +45°C. Ideally, you should charge and
store the battery inside your house or in a warm
garage when the outside temperature is low. In
this case, you should only fit the battery onto your
bike just before using it.

5.1.3 Installing the battery

1. a) Down tube battery: Insert the battery into the bat-
tery holder of the Pedelec from the front/above. At the
same time, the key must be in the lock and must be
turned anticlockwise.
b) Seat tube battery: Insert the battery into the holder
of the Pedelec from the left by tilting it outwards at
roughly 45°.
DOWN TUBE BATTERY
Installing the battery
2. Press the battery down into the holder until the lock-
ing mechanism engages. Now turn the key clockwise
and remove it. The battery is now locked in place.
DOWN TUBE BATTERY
Locking the battery
3. Make sure the battery is firmly in place.
Original User Manual | Pedelec Impulse 2.0
SEAT TUBE BATTERY
SEAT TUBE BATTERY
13