Removing/Fitting Wheels (Attix 751-71); Removing/Fitting Grips; Attix 751-71); Removing/Fitting Lock (All Models) - Nilfisk-ALTO ATTIX 751-01/-11/-21 Repair Manual

Nilfisk
ALTO

3.4 Removing/fitting wheels (Attix 751-71)

3.5 Removing/fitting grips (all models except Attix 751-71)

3.6 Removing/fitting lock (all models)

Attix7_ver.1.0_140105
Troubleshooting
Attix7 3650
Attix7 3652
Attix7 3655
E
1. Lever off the wheel cap
(1) with a screwdriver.
2. Lever the clamping ring
(2) off the axle with a
screwdriver, and remove
the wheel.
3. Fit in the reverse order.
Do not push the clamping
ring too far onto the axle
otherwise the wheel will
not turn freely.
1. Undo the six screws (1)
with a Phillips screwdriver,
and remove the grips.
2. Fit in the reverse order.
1. Lever off the lock (1)
with a screwdriver.
2. Fit in the reverse order,
pressing the lock (1) firmly
over the latch so that you
hear it snap into place.
26/59