Door Reversal (Optional) - Whirlpool W10679043A Installation Instructions Manual

Door Reversal (optional)

The following instructions are for models with a round and
square-shaped doors.
Tools needed:
Min. 8" long TORX T25
® †
screwdriver
Reverse door swing round-shaped door – single handle
1.
Remove door from dryer
IMPORTANT: If the protective film has not yet been removed
from the dryer, peel the film from the dryer door before
proceeding.
Using a TORX T25 screwdriver, remove the 4 screws securing
®
the door hinge to the dryer and lift up and out to remove the
door. Place the door on a soft towel or other non-scratch
surface. Reinstall the 4 screws in the holes.
16
#2 Phillips screwdriver
2.
Move the door strike
Using a T25 screwdriver, remove the 2 screws securing
®
the door strike to the door frame of the dryer. Rotate the
strike 180° and attach to the opposite side of dryer door
frame, as shown.
3.
Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.
†