Connect Outlet Hose; Level Dryer - Whirlpool W10679043A Installation Instructions Manual

Connect Outlet Hose

1.
Attach hose
Attach the goose neck fitting of the provided 6' (1829 mm)
drain hose to the drain valve at the bottom of dryer back
panel. Screw on coupling by hand until it is seated on valve
connector.
2.
Tighten coupling
Using channel locks, tighten the coupling an additional
two-thirds turn.
NOTE: Do not over tighten. Damage to the coupling can
result.
3.
Secure drain hose system
Laundry Tub Standpipe
4.5" 4.5" 4.5" 4.5"
(114 mm) (114 mm)
(114 mm) (114 mm)
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie.
14

Level Dryer

Check levelness of dryer from
side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture sensing
system to operate correctly. If forward slope of dryer is
greater than 1" (25 mm), water could run out from front
of filter.
Wall
4.5" 4.5"
(114 mm) (114 mm)
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once dryer is level, make sure all four legs are snug against
the floor and dryer does not rock.
1.
Level dryer
Place
level here
Not Level LEVEL
2.
Adjust leveling legs
Not Level