Whirlpool W10679043A Installation Instructions Manual page 19

9.
Reinstall inner door assembly
Position the door with the inside of the door facing up. Using
a Phillips screwdriver, reinstall the 10 screws securing the
inner door to the outer door.
10.
Reinstall door on dryer
Using a T25 screwdriver, remove the 4 screws on the
®
dryer. Insert the tabs on the hinge into the mounting slot
and slide down to engage the top tab. Secure in place
with the 4 screws removed earlier.
Reverse door swing round-shaped door – double handle
1.
Bottom
of door
IMPORTANT: If the protective film has not yet been removed
from the dryer, peel the film from the dryer door before
proceeding.
Using a T25
door hinge to the dryer and lift up and out to remove the door.
Place the door on a soft towel or other non-scratch surface.
Reinstall the 4 screws in the holes.
2.
Using a T25
the door strike to the door frame of the dryer. Rotate the
strike 180° and attach to the opposite side of dryer door
frame, as shown.
Remove door from dryer
screwdriver, remove the 4 screws securing the
®
Move the door strike
screwdriver, remove the 2 screws securing
®
19