Electrical Installation - U.s.a. Only; Power Supply Cord Connection - Whirlpool W10679043A Installation Instructions Manual

Electric Installation - U.S.A. Only
Before you start: disconnect power.
1.
Choose electrical connection type
Power supply cord 4-wire receptacle
(NEMA Type 14-30R).
Go to "Power Supply Cord Connection."
Power supply cord 3-wire receptacle
(NEMA Type 10-30R).
Go to "Power Supply Cord Connection."
4-wire direct connection:
Go to "Direct Wire Connection."
3-wire direct connection:
Go to "Direct Wire Connection."
NOTE:
If local codes do not permit connection of a
cabinet-ground conductor to neutral wire, go to "Optional
3-wire connection." This connection may be used with
either a power supply cord or a direct wire connection.
2.
Remove terminal block cover
Remove hold-down screw and terminal block cover.
8

Power Supply Cord Connection

Power supply cord strain relief:
1.
Attach power supply cord strain relief
Remove the screws from a 3/4" (19 mm) UL listed strain relief
(UL marking on strain relief). Put the tabs of the two clamp
sections (C) into the hole below the terminal block opening
(B) so that one tab is pointing up (A) and the other is pointing
down (D), and hold in place. Tighten strain relief screws just
enough to hold the two clamp sections (C) together.
A
B
C
D