Table of Contents
Advertisement
Available languages
Available languages
Connect Outlet Hose
1.
Attach hose
Attach the goose neck fitting of the provided 6' (1829 mm)
drain hose to the drain valve at the bottom of dryer back
panel. Screw on coupling by hand until it is seated on valve
connector.
2.
Tighten coupling
Using channel locks, tighten the coupling an additional
two-thirds turn.
NOTE: Do not over tighten. Damage to the coupling can
result.
3.
Secure drain hose to back of dryer
(optional)
Push each of the 3 triangular-end cable ties into the holes in
the groove of the back panel and secure drain hose to dryer.
14
4.
Secure drain hose system
Laundry Tub
Standpipe
4.5"
4.5"
4.5"
4.5"
(114 mm)
(114 mm)
(114 mm)
(114 mm)
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie.
Level Dryer
1.
Level dryer
Place
level here
Check levelness of dryer from
side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture sensing
system to operate correctly. If forward slope of dryer is
greater than 1" (25 mm), water could run out from front
of filter.
Not Level
Wall
(114 mm)
(114 mm)
LEVEL
Not Level
4.5"
4.5"
Advertisement
Table of Contents
