Wps - Push Button Setup - D-Link DCS-5211L User Manual

Section 2 - Installation

WPS - Push Button Setup

Alternatively, you may create a connection to the camera using Wi-Fi Protected Setup (WPS).
To create a WPS connection:
Step 1
Press and hold the WPS button for three seconds. The blue WPS status
LED above the button will blink.
Step 2
Press the WPS button on your router within 60 seconds. The WPS button
is usually on the front or side of your router. On some routers, you may
need to log in to the web interface and click on an on-screen button to
activate the WPS feature. If you are not sure where the WPS button is
on your router, please refer to your router's User Manual.
The 5222L will automatically create a wireless connection to your router.
While connecting, the green LED will flash and your camera will reboot.
WPS Button
D-Link DCS-5211L/DCS-5222L User Manual 16