Wps - Push Button Setup - D-Link DCS-942L User Manual

Section 2 - Installation

WPS - Push Button Setup

Alternatively, you may create a connection to the camera using Wi-Fi Protected Setup (WPS).
To create a WPS connection:
Step 1
Press and hold the WPS button for three seconds. The blue WPS status LED above the
button will blink.
Step 2
Press the WPS button on your router within 60 seconds. The WPS button is usually on the
front or side of your router. On some routers, you may need to log in to the web interface
and click on an on-screen button to activate the WPS feature. If you are not sure where the
WPS button is on your router, please refer to your router's User Manual.
WPS Button
The DCS-942L will automatically create a wireless connection to your router. While
connecting, the green LED will flash and your camera will reboot.
D-Link DCS-942L User Manual 14