Section 2 - Installation
WPS - Hardware Push Button Setup
Alternatively, you may create a WPS connect using the WPS Button on the back
of the camera.
To create a WPS connection:
Press and hold the WPS button on the side of the camera for three seconds.
The blue WPS status LED above the button will blink.
Press the WPS button on your router within 60 seconds. The WPS button is
usually on the front or side of your router. On some routers, you may need to log
in to the web interface and then click on an onscreen button to activate the WPS
feature. If you are not sure where the WPS button is on your router, please refer
to your router's User Manual.
The DCS-930 will automatically create a wireless connection to your router.
While connecting, the green LED will flash and your camera will reboot.
D-Link DCS-930 User Manual