BMW HP2 Sport Rider's Manual page 132

with BMW Motorrad ABS
10
130
Insert ABS sensor into hole
and install screw 1.
z
Remove front-wheel and rear-
wheel stand.
Ease brake calipers onto brake
disks.
OE
Install securing screws 1 on left
and right with specified torque.
Radial brake caliper on
slider tube
22 lb/ft (30 Nm)
Remove adhesive tape from
wheel rim.
Braking efficiency is im-
paired if the brake pads are
not correctly bedded against the
disks.
Before driving off, check that the
braking effect kicks in without
any delay.
Operate brakes several times
until brake pads contact brake
disk.
with BMW Motorrad ABS
Clip in retaining clips of ABS
sensor cable on brake line.
The cable of the ABS sen-
sor could chafe through if
it comes into contact with the
brake disk.
Make sure that ABS sensor cable
is routed correctly.
Make sure that ABS sensor
cable is routed as shown.
OE