Adjusting The Buckle; Removing The Buckle - Britax Chaperone User Manual

50 Securing Your Child
IMPORTANT: Harness straps must hang as shown by
straps behind the harness yoke. Pull on the harness straps to ensure the harness
strap webbing is secured within the slots of the harness yoke.

Adjusting the Buckle

IMPORTANT: Your infant carrier has been assembled with the buckle
strap in the inner position for infants weighing less than 5 kg (11 lbs).
Once your child reaches 5 kg (11 lbs) re-route the buckle position to the
outer position. Follow the steps below to adjust the buckle position. See
page 49 for important information for adjusting the harness straps for the
fit of your child.

Removing the Buckle

1 Remove the infant carrier from the base if attached.
2
Pull the plastic flaps on the cover
from the infant carrier shell.
above. Do not tuck the
3
Pull the infant carrier cover and foam
back to access the buckle slots.
4
Locate the buckle strap retainer
attached to the opposite end of
the buckle strap on the bottom of
the infant carrier shell.
6
Turn the buckle strap retainer so
that the short side will go through
the slot in the infant carrier shell
and cover.
Securing Your Child 51
5
Pull the buckle strap retainer away
from the infant carrier to loosen.
7
Thread the buckle strap retainer
through the slot in the infant
carrier shell and cover.