Adjusting Buckle Position; Overhang - Britax GROW WITH YOU CLICKTIGHT Series User Manual

GROW WITH YOU CLICKTIGHT / PLUS User Guide
In some cases, the vehicle head
restraint can prevent the child seat
head restraint from being raised high
enough to properly adjust the harness
for the fit of your child� DO NOT force
the child seat head restraint past the
vehicle head restraint� Doing so could
cause the child seat not to perform
as intended� If the location of the vehicle head restraint
interferes with the child seat head restraint, raise or remove
the vehicle head restraint� If the vehicle head restraint
cannot be removed, move the child seat to the upright
position or try a different seating location�

Overhang

Harness Mode
It is important that the base of the child
seat rests completely flat on the vehicle
seat with no side overhang� As seen
in the illustration, it is permissible to
allow up to 3 in� (7�6 cm) of the base to
hang over the front edge of the vehicle
seat� If the vehicle seat does not allow
enough of the child seat base to make
contact, adjust the recline angle to
a more upright position� Not doing
so could cause the child seat to not
perform as intended�
Booster Mode
IMPORTANT:
booster mode, the base of the child seat must fit completely
on the vehicle seat�

Adjusting Buckle Position

Removing the Buckle
1� Unbuckle the harness by
pressing the release button
and pulling the tongues�
WARNING!
Overhang is not allowed in booster mode� In
3"
3"
Harness Mode
23 23