Steering Wheel; Adjusting The Steering Wheel; Roll Over Protective Structure; Roll Over Protective Structure (Rops) - Shibaura CM314 Operator's Manual

STEERING WHEEL

ADJUSTING THE STEERING WHEEL

The CM mower is equipped with an adjustable
steering wheel which can telescope and tilt.
To telescope the wheel, turn the wheel hub A
to the left and raise or lower the steering wheel
to the desired height. Then turn the hub to the
right to lock it into position.
NOTE: When locking the hub into position,
do not overtighten.
To tilt the wheel, pull up on the lever B and
move the steering wheel fore or aft the desired
position. If the wheel is not held in position when
the lever is raised, the steering wheel will spring
to its most forward position. Use this feature to
gain additional clearance when mounting and
dismounting the CM mower.

ROLL OVER PROTECTIVE STRUCTURE

(ROPS)
A Roll Over Protective Structure (ROPS) and
seat belts are standard equipment.
DO NOT remove a ROPS and seat belts. ROPS
when used with seat belt is effective in reducing
injuries during unit overtur n accidents.
Overturning the unit without a ROPS can result
in serious injury or death.
WARNING! WHEN IMPROPERLY OPERA-
TED, THE UNIT CAN ROLL OVER OR
UPSET! FOR LOW CLEARANCE USE ONLY,
THE ROLL BAR CAN BE LOWERED. NO
PROTECTION IS PROVIDED WHEN THE
COMMERCIAL MOWER IS OPERATED WITH
THE ROLL BAR IN THE LOWERED
POSITION. ALWAYS RAISE THE ROLL BAR
IMMEDIATELY AFTER LOW CLEARANCE
USE. WHEN THE UNIT IS BEING DRIVEN TO
AND FROM A LOW CLEARANCE JOB, THE
ROLL BAR SHOULD BE IN THE RAISED
POSITION. WHEN THE ROLL BAR IS
LOWERED, USE OF THE SEAT BELT IS NOT
RECOMMENDED. ALWAYS USE THE SEAT
BELT WHEN THE ROLL BAR IS RAISED.
SEAT BELTS SAVE LIVES WHEN THEY ARE
USED.
OPERATION
ADJUSTMENT THE STEERING WHELL

ROLL OVER PROTECTIVE STRUCTURE (ROPS)

2-2
A
B