Mitsubishi Heavy Industries SRK20ZJX-S Service Manual page 12

(c) Swing
1)
Swing flap
Flap moves in upward and downward
directions continuously.
In HEAT operation
Approx. 20°(25°)
Approx. 75°(70°)
Note (1) value in ( ) are for the model SRK20~50ZJ-S.
(d) Memory flap (Flap or Louver stopped)
When you press the AIRFLOW (UP/DOWN or LEFT/RIGHT) button once while the flap or louver is operating, it stops swinging
at the position. Since this angle is memorized in the microcomputer, the flap or louver will automatically be set at this angle when
the next operation is started.
(e) When not operating
The flap returns to the position of air flow directly below, when operation has stopped.
SRF series
Control the flap by AIRFLOW
(a) Flap
Each time when you press the AIRFLOW
(Flap stopped)
Angle of Flap from Horizontal
Remote controller
display
COOL , DRY, FAN
HEAT
(b) Swing
1)
Swing flap
Flap moves in upward and downward directions continuously.
In HEAT operation
Approx.44°
Approx.5°
(c) Memory flap (Flap stopped)
When you press the AIRFLOW button once while the flap is operating, it stops swinging at the position. Since this angle is mem-
Approx. 45°
orized in the microcomputer, the flap will automatically be set at this angle when the next operation is started.
(d) When not operating
Approx. 75°
The flap returns to the position of air flow directly below, when operation has stopped.
In COOL, DRY, FAN operation
Approx.5°(10°)
Approx. 60°
 
(UP/DOWN) button on the wireless remote controller.
 
(UP/DOWN) button the mode changes as follows.
Approx. 60° Approx. 50°
Approx. 44° Approx. 32°
In COOL, DRY, FAN operation
Approx.60°
Approx.12°
Approx.
5°
Approx. 60°
2)
Swing louver
Louver moves in left and right directions continuously.
(Swing)
Approx. 38° Approx. 21.5°
Approx. 21.5° Approx. 12°
11
- -
'10 • SCM-SM-094
Approx. 12°
Approx. 5°