Dell 5330dn Service Manual page 70

Display
Paper Jam 2...
Duplex jam 0...
Duplex jam 1...
Standard Bin Full/
Standard Bin is 90%
Full
Optional Bin1 Full
Open Heat
Open Heat Error
Power Cycle
Low Heat/
Low heat Error
Power Cycle
Over Heat
Overheat Error
Power Cycle
LSU Motor Error/
LSU Motor Error/
Power Cycle
Hsync Error/
LSU Hsync Error
Power Cycle
Fuser Error
Fuser Fan Locked
Power Cycle
SMPS Error
SMPS Fan Locked
Power Cycle
Fuser Error/
Fuser Not Installed
Check Rear Door
Inner Temp. Error/
Inner Temp. Error
Power Cycle
Deve Motor Error/
Deve Motor Locked
Power Cycle
Service Manual
Adjustment and Troubleshooting
Meaning
Paper has jammed in the paper exit
area.
Paper has jammed during duplex
printing.
Paper has jammed during duplex
printing.
The output tray is full.
The output tray of output expander
is full.
There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the
There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the
There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the
A problem has occurred in the
LSU(Laser Scanning Unit).
A problem has occurred in the
LSU(Laser Scanning Unit).
There is a problem in the cooling
fan of the printer.
There is a problem in the SMPS fan
of the printer.
The fuser unit is not installed or not
detected.
There is a problem in your printer
system.
There is a problem in the
development motor of the printer.
Suggested solutions
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
The output tray can hold up to 250 sheets of plain
paper. Once the paper is removed from the output
tray, the printer resumes printing.
The output expander can hold up to 650 sheets of
plain paper. Once the paper is removed from the
output expander, the printer resumes printing.
problem persists, see the fuser error flow chart.
problem persists, see the fuser error flow chart.
problem persists, see the fuser error flow chart.
Unplug the power cord and plug it back in. If the
problem persists, see the LSU unit error flow chart.
Unplug the power cord and plug it back in. If the
problem persists, see the LSU unit error flow chart.
Open and then close the rear door.
Unplug the power cord and plug it back in.
Install the fuser unit or open and then close the rear
door.
Unplug the power cord and plug it back in.
Unplug the power cord and plug it back in.
4-13