Water Circuit - Chausson V594S User Manual

CHAP. XI operation of appliances

wAtEr CIrCuIt

n
Your camping car is equipped with
- a clean water tank,
- a waste water tank
Filling
n
Standard :
The clean water tank is filled through an opening with a
screwon stopper located on the unit exterior and indicated
with a pictogram.
Double :
One of our models is equipped with a traditional filling system
inside the living unit in the kitchen block area and another
specific system outside the unit. Filling is done under domestic
pressure (2.5 – 3 bars) with a special adaptor that should be
placed at the end of the water input hose.
To open and close the cap with the key, hold the cap in place to
keep it from movng when you turn the key in the lock
:
.
If the control panel is in fill mode.
An LED will light up to indicate that the
tank is almost full and that filling should
be stopped.
Internal power supply
n
The water supply uses a 12 V electric pump.
Pressurize the pump as follows:
- Check that all taps and mixers are closed (cold water and
hot water).
- Switch on the 12 V pump, using the switch on the electric
control panel.
- purge the cold water and hot water circuits using each
tap or mixer.
- The installation is then ready to operate.
A purge fault (presence of air) may prevent the water heater
from operating.
WC WC
! !
55