Chausson V594S User Manual page 73

CHAP. XVII Camper A CLASS
ImPortAnt: It is strongly recommended to always empty water in the circuit, tank and water heater when there is a risk of freezing
and your camper is not being used.
DRAINING OF DRINKING WATER
n
To drain hot and cold water, proceed as follows:
1 - Turn the pump off on the control panel.
2 - Empty the reservoir by opening the cap(s). A valve
is located inside the vehicle close to the reservoir.
3 - Open the water heater faucet (see the chapter
on WATER HEATER/HEATING)
4 - When the reservoir and the water heater are empty, open the
faucets and pump starter for a few seconds.
5 - When the circuit is empty, close the drinking water reservoir
valve and the heater drain valve.
DRAINING OF WASTE WATER
n
- All waste water (washbasin, sink and shower) is collected in a
rigid tank with a capacity of around 100 liters located under the
vehicle floor.
- A sensor signals when the tank is full, the warning light comes
on and there is a beeping noise on the control panel.
If you use your camper in very cold weather, the MANUFACTURER cannot guarantee that the waste water circuit will be fully freeze
72
safe. Remember that insulation without a heat supply only delays thermal exchange.
- Reservoirs are emptied using a manual valve for wastewater and
by removing a stopper for the clean water containers located on
the side of and under the vehicle
wArnInG:
.
WC WC
! !