Eberspächer Heater - Chausson V594S User Manual

CHAP. XI operation of appliances
EBErSPäCHEr HEAtEr
n
Switching on
n
The indicator lamp in the control panel lights on start-up. The
glow pin is switched on and the fan starts to turn slowly.
Monitor this!
n
The fan comes on by itself at first (cold air) if there is too much
residual heat from a previous heating operation in the heat
exchanger. Once the residual heat has been eliminated start-up
commences.
Airtronic start-up
n
The fuel starts to flow after about 60
seconds and the air-fuel mix is ignited in
the combustion chamber.
Once the combination sensor (flame
sensor) has recognised the flame, the
glow pin will be switched off after about
60 seconds.
The heater will reach the «POWER» setting after another couple
of minutes (amount of maximum fuel and maximum fan speed).
Selecting the temperature on the control panel
n
The inside temperature is pre-set using the rotary adjustment
knob to between +10°C and +30°C depending on the heater
selected, the area to be heated and the outside temperature.
The setting chosen is an experimental value.
Adjustment when heater is in service
n
The temperature of the space, even of the suctioned hot
air, is monitored constantly when the heater is in service.
Adjustment commences when the temperature is higher than
set on the control knob. Four adjustment levels are provided so
that the heat current may be adjusted to match precisely the
heat delivery required.
The fan speed and fuel quantity correspond to the respective
adjustment levels. If the adjusted temperature is still exceeded
when the equipment is on its lowest setting, the heater will
move to the «STOP» setting. The fan will operate by inertia for
about four minutes as part of the cooling process. The fan will
then continue to operate at minimum speed (circulation of air)
or even switched off (cold air) until switched on again
?
WC
!
WC
!
51