Lexmark Optra C710 User Manual page 162

Status messages (continued)
Message
Waiting
Not Ready
Ready Hex
Locking Menus
Unlocking Menus
Disabled Menu
Enabled Menu
Supplies
Activating Menu Changes
Parallel
Parallel x
Serial x
Network x
LocalTalk x
148
Chapter 8: Understanding printer messages
Meaning
The printer has received a page of data to print but is waiting for an End of Job or
Form Feed command or for additional data.
• To print the contents of the print buffer, press
• To cancel the print job, press
Press Select . Press Menu>
line. Press Select .
The printer is not ready to receive or process data, because someone selected
when another message was displayed.
Stop
• Press to remove the printer from the Not Ready state.
Go
• To cancel the print job, press
Press . Press
Select Menu>
line. Press .
Select
Hex Trace diagnostic mode is active, and the printer is ready to receive data. Use
Hex Trace to isolate the source of a print job problem. With Hex Trace selected, all
data sent to the printer is printed in hexadecimal and character representation.
Control code strings are printed, not executed.
To exit Hex Trace mode, turn the printer off or reset the printer. To reset the printer,
press or . When the Job Menu is displayed press
Menu> <Menu
or until Reset Printer appears on the second line. Press
Menu> <Menu
Someone has locked the menus. While the menus are locked, users cannot
change the printer default settings from the operator panel. See "Locking the
menus" on page 14 for more information.
Someone has unlocked the menus. Users can now change the printer default
settings from the operator panel. See "Locking the menus" on page 14 for more
information.
Menus have been locked, or disabled. See page 14 for more information.
Menus have been unlocked. See page 14 for more information.
At least one of the printer supplies needs attention. You may have a paper tray that
is low on paper or a print cartridge that needs replacing. Press
open the Supplies Menu. See page 17 for more information about the menu.
This message is displayed when the printer is being reset. To activate some of the
printer settings, the printer must restart. No buttons are active when this message
is displayed.
The standard parallel interface is the active communication link.
The specified parallel interface is the active communication link.
The specified serial interface is the active communication link.
The specified network interface is the active communication link.
The LocalTalk interface is the active communication link.
Go.
Menu> or <Menu until the Job Menu is displayed.
or <Menu until Cancel Job appears on the second
Menu> or <Menu until the Job Menu is displayed.
or until Cancel Job appears on the second
<Menu
. press
Select
.
Select
or to
Menu> <Menu