Loading Paper In The Trays - Lexmark Optra C710 User Manual

Loading paper
in the trays
Note:
Do not place paper into
the duplex unit tray.
panel, MarkVision, or printer driver before sending multi-
purpose jobs to print.
• If you are printing a job using manual feed, send the job
to the printer and then wait for the
to appear on the display. Place media in the multipurpose
feeder and press
• Print transparencies only after printer has fully warmed.
The procedures for loading paper in all the trays (the standard
250-sheet tray and the optional 250-sheet trays) are the same.
Refer to the Setup Guide for detailed instructions.
The printer lets you know when you need to load paper in the
trays. If a tray has less than 50 sheets of paper, the
status message appears on the display. Press
Supplies
to open Supplies Menu. Scroll through the list of sup-
<Menu
plies that need attention. The menu indicates whether a tray is
missing, low, or empty.
When you change the paper in the tray, make sure the paper
guides are in the correct positions. The position of the rear paper
guide informs the printer of the size paper loaded in the tray.
Feeding paper when the rear paper guide is not in the correct
position may result in misfeeds or paper jams.
If you load a different type of media, change the Paper Type set-
ting in the Paper Menu. Selecting the correct paper type guaran-
tees optimal print quality for that media. See "Media guidelines"
on page 98 for information about the changes the printer makes
for specific media. For more information about changing the
Paper Type setting, see page 22 or refer to the Setup Guide.
The paper size and the paper type also must be set correctly for
tray linking to work as expected. See page 109 for more infor-
mation about tray linking.
Chapter 6: Loading paper in the trays
Load Manual
.
Go
message
or
Menu>
105