ZyXEL Communications Omni TA128 Quick Start Manual page 30

ZyXEL
If the Omni TA128 does not respond as above, an error has occurred.
If the response is:
OK
SPID Error!
This indicates an incorrect SPID number was entered.
If the response is:
OK
This indicates a general failure. The SPID was not verified. This would occur if the ISDN
line is not connected to your Omni TA, or if you have selected the wrong Switch type.
Once the SPID(s) are entered and accepted, you will see the LNK LED light up. If you
are not able to get the SPID(s) to accept correctly, verify the number(s) with your phone
company again. You should recheck all your cable connections before calling your
phone company. If it still does not work, you will need your phone company's support to
make sure the SPIDs are correct and the line you ordered has been correctly setup.
Note: We recommend that you always make sure the cable connections are correct
and securely in place. This will make it easier for you to isolate the problem
area when talking to our technical support staff or the phone company.
Correctly entered and accepted SPID numbers will be stored in nonvolatile memory. That
way you won't need to enter the SPID again, even if the power is turned off. However, if
you perform a hardware reset, you will need to re-enter the SPID number(s) and switch
type again. Make sure you write down or store all the relevant information so it can be
retrieved at a later date.
Configuring the Omni TA128 from a Terminal Program
Omni TA128 Quick Start Guide
B-7