ZyXEL Communications Omni TA128 Quick Start Manual page 29

Omni TA128 Quick Start Guide
Type:
ATP0<Enter>
Omni TA128 should respond:
OK
Switch Type: Northern Telecom DMS100
At this point you should save the settings.
Type:
AT&WZ<Enter>
The Omni TA128 responds:
OK
Entering SPIDs
You are ready to enter the SPID (Service Profile Identifier) number. Unless your switch
type is AT&T 5ESS with Point-to-Point protocol, SPID(s) will be needed. The ISDN
switches use Service Profile Identifier (SPID) to represent the network services to which
the Omni TA128 has subscribed. Each SPID corresponds to one Terminal End Point
Identifier. Different switches may provide different rules for the SPID number format.
You should get the SPID number from your local phone company.
To program your SPID number into the your Omni TA:
Type:
ATSPID0= n (n is the SPID provided by your phone company)
Omni TA128 should respond:
OK
SPID Correct! (This may take up to 30 seconds)
This response indicates the SPID number was accepted.
If a second SPID is required.
Type:
ATSPID1= n (n is the second SPID provided by your phone company)
Omni TA128 should respond:
OK
SPID Correct!
B-6 Configuring the Omni TA128 from a Terminal Program
ZyXEL