ZyXEL
Four - Driver Installation and Configuration
This chapter contains step-by-step procedures for installing the Windows 95 drivers, and
using the ISDN Configuration Manager to configure your Omni TA.
Installing the Windows 95 Driver
Step 1 - Make sure the power to the Omni TA128 is turned ON before your PC is turned
on.
Step 2 - Start Windows 95. Windows will automatically detect your Omni TA128 and
prompt you for the driver.
Step 3 - Select "Driver from disk provided by manufacturer", then click OK
Step 4 - Insert the Omni TA128 "Firmware and driver diskette" into your floppy drive,
select "A:\" in the "Copy manufacturer's files from" dialog box, and click OK.
Step 5 - Select the Omni TA128 driver and click Next.
Step 6 - Click Finish on the following screen to completes the installation of your Omni
TA128 modem driver.
Driver Installation and Configuration
Omni TA128 Quick Start Guide
9
Page