Unit Limitations; Component Location - York PCG4 Series Installation Manual

York pcg4 series single package air conditioner/gas heat

Hide thumbs

Table of Contents

LIMITATIONS

These units must be installed in accordance with the following:

In U.S.A.:

1. National Electrical Code, ANSI/NFPA No. 70 - Latest Edition

2. National Fuel Gas Code, ANSI Z223.1 - Latest Edition

3. Gas-Fired Central Furnace Standard, ANSI Z21.47a. - Latest Edi-

tion

4. Local building codes, and

5. Local gas utility requirements

In Canada:

1. Canadian Electrical Code, CSA C22.1

2. Installation Codes, CSA - B149.1.

3. Local plumbing and waste water codes, and

BLOWER MOTOR

TXV

EVAPORATOR COIL

INDOOR BLOWER

COMPRESSOR

REMOVABLE

BASE RAILS

FIGURE 1: Component Location

Table 1: Unit Limitations

Model

Unit Voltage

208/230-1-60

Johnson Controls Unitary Products

4. Other applicable local codes.

Refer to unit application data found in this document.

After installation, gas fired units must be adjusted to obtain a temperature

rise within the range specified on the unit rating plate.

If components are to be added to a unit to meet local codes, they are to

be installed at the dealer's and/or customer's expense.

Size of unit for proposed installation should be based on heat loss/heat

gain calculation made according to the methods of Air Conditioning

Contractors of America (ACCA).

This furnace is not to be used for temporary heating of buildings or

structures under construction.

FAN MOTOR