Air Conditioner Selector Switch; Tv Antenna - Winnebago BRAVE Owner's Manual

Furnace fan operation is available only if pro-
vided by the furnace manufacturer. The purpose
of furnace fan operation simultaneously with
cooling fan is to better circulate air within the
conditioned space for a more uniform space tem-
perature.
All cooling functions controlling to setpoint
have a short cycle protection time delay of 3 min-
utes. There will be no delay if the cycle OFF time
exceeds 3 minutes.
*There is no heat switch or furnace function
available with the Cool Only thermostat.
AIR CONDITIONER SELECTOR
SWITCH
The selector switch is located behind a door
above the microwave oven.
Since an external 110-volt power source
(shoreline hook-up) can only handle operating
one roof air unit at a time, the selector switch is
provided to allow you to select the unit of your
choice - front or rear.
Both roof air units can be used at the same
time in vehicles equipped with 5,000, 6,500 or
7,000 watt auxiliary generators if the 110-volt
shoreline is plugged into the auxiliary generator.
To allow generator start-up without excessive
load, follow these steps:
1. Be sure both roof air units are switched OFF.
2. Start the generator.
3. Turn the A/C selector switch to the FRONT
position.
4. Switch both roof air units ON.
APPLIANCES & INTERIOR FEATURES
TV ANTENNA (Optional)
The TV antenna on your motor home can be
easily raised, rotated a full 360° and lowered
from inside the vehicle by simply turning a crank
or rotating knob. A built-in signal amplifier de-
signed to strengthen signals, is controlled by a
power switch built into the TV jack assembly.
The signal amplifier is housed inside the an-
tenna with the circuit board connected directly to
the antenna elements. Power to operate the am-
plifier (12-volt DC) is supplied through the
downlead cable which also carries the TV signals
to the TV set. The power supply separates the 12-
volt DC from the TV signals and provides a place
for attaching the TV set and the 12-volt power
source.
OPERATION
Raising Antenna - Turn elevating crank
clockwise in "UP" direction about 13 turns or un-
til some resistance to turning is noted. Antenna is
now in operating position. Turn amplifier power
switch "ON" to receive TV signal.
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
Rotating Antenna - Make sure antenna is in
the "UP" position. Pull down on rotating knob
until it disengages ceiling plate and rotate for best
picture and sound on TV set.
SECTION 8
WARNING
8-11