Cb Radio Wiring; Battery Condition Meter - Winnebago BRAVE Owner's Manual

WARNING
To prevent wiring damage, it is
essential when replacing the cables
on the battery, or when using a
"booster" battery, that the positive
post and the positive cable be
attached and the negative post and
negative cable be attached. The posts
are marked (+) plus and (-) minus. If
a "fast charger" is used while battery
is in the motor home, disconnect both
battery cables before connecting the
charger. Never attempt to charge or
boost a frozen battery.

BATTERY CONDITION METER

See related item under "Monitor Panel" in sec-
tion 8, Appliances.
AUX. START SWITCH
See section 2, Driving Your Motor Home for
information on Aux. Start Switch.
AUXILIARY BATTERY (Aux. Batt)
SWITCH
See section 2, Driving Your Motor Home, for
information on the Auxiliary Battery Switch.

CB RADIO WIRING

(Optional)
If your coach is pre-wired for CB radio instal-
lation, the wires are located in the main wiring
harness beneath the instrument pod. Lift the in-
strument pod as shown to access the wiring har-
ness.
ELECTRICAL SYSTEMS
CB Radio Wiring
Look for a pair of wires, purple (+) and green
(-), with flag labels.
Be sure to read the wire labels before install-
ing a CB radio. The labels contain important in-
formation and cautions.
TO
CB RADIO
RED BLK
CB POWER PROVISON
PURPLE
GREEN GROUND
COAX
(SEE REVERSE ALSO)
CB ANTENNA
CABLE
SWR Adjustment
To adjust CB antenna SWR (standing wave
ratio), turn the adjusting ring of the antenna to
achieve lowest SWR reading. This procedure
will help optimize transmitting and receiving ca-
pabilities of the CB radio system.
SECTION 6
TO
CB RADIO WIRING
LABEL
+12 V
ANTENNA
WIRE ASM-IP, MAIN
6-9