Entrance Step - Winnebago BRAVE Owner's Manual

SECTION 2
DRIVING YOUR MOTOR HOME
toms of running out of fuel immediately
after such an occurrence, the fuel pump
shut-off switch may need to be reset.
Consult your Ford chassis operating
guide for additional information.
ENTRANCE DOOR LOCK
AND HANDLE
The entrance door may be opened by
pulling the door handle outward. When the door
is locked, neither the inside nor the outside door
handle can be operated. It can be locked and un-
locked from the outside of the vehicle by insert-
ing the key into the lock and turning.
Pull
Entrance Door Handle - Outside
To lock the door from inside, rotate the lock
levers as indicated. The deadbolt lock is for add-
ed security and should be used as a security night
lock.
Door Latch Handle
Entrance Door Handle - Inside
2-4
Deadbolt Lock
Lubricate the locks periodically with graphite
to maintain good working condition.
CAUTION
When releasing security night lock,
be sure to retract bolt before opening
door latch to prevent drag on bolt pin.
Instruct all passengers in operation of
this door catch system as well as
emergency exit window.
NOTE: Keys should always be removed when
leaving the vehicle. Since doors can be
locked without keys, make sure they have
been removed from the ignition before
locking the driver's compartment.
ELECTRIC ENTRANCE
STEP
The power switch for the electric entrance step
is located to the left of the main entry door as you
enter the coach.
Automatic Mode (Operates with Door)
With the Power Switch in the On position the
step is in Automatic Mode. This means it will
extend and retract automatically whenever the
door is opened or closed. This is done by means
of a magnetic door switch attached to the lower
hinged edge of the screen door section of the
entrance doors. The steps will extend when the
screen door is opened, and retract when the
screen door is closed. With the power switch in
the Off position the step can be kept in the ex-
tended or retracted position as described below.
Stationary Extended Mode
To keep the step in the extended position:
• turn the Power Switch to On,
• open the screen door to extend the step,
• then turn the Power Switch to Off.
The step will now stay extended whether the
door is opened or closed. This position is normal-
ly used when parked at a campsite or whenever
people are going to be entering and exiting the
vehicle frequently.