Brakes - Beta Urban 125 Service Manual

3
FRONT BRAKE
Check
To check the wear of the front brake, visu-
ally inspect the brake pad ends by look-
ing at the brake caliper from the front.
The brake linings should be at least 2
mm thick. If the linings are thinner, replace
the pads immediately.
(see section 5, " Replacements", on page 66).
Note
Carry out the check at the intervals shown
in the table on page 57.
REAR BRAKE
Check
To check the wear of the rear brake, visu-
ally inspect the brake pad ends by look-
ing at the brake caliper from above. The
brake linings should be at least 2 mm
thick. If the linings are thinner, replace
the pads immediately.
(see section 5, " Replacements", on page 66).
Note
Carry out the check at the intervals shown
in the table on page 57.
2 mm
GB
50