Copy Troubleshooting - Lexmark 5000 Series User Manual

•
If your camera does not allow you to change the paper size setting, use the control panel to change the paper
size to 4 x 6 in. (10 x 15 cm).
1
Insert the USB cable that came with your camera to the camera, and insert the other end into the PictBridge
port on the front of the printer.
2
Turn the camera on and choose your first photo using the camera control panel.
3
Wait for PictBridge Printing to appear on the display of the printer control panel.
Note: If Paper/Photo Size Error appears, press
4
Press .
5
Press or repeatedly until Photo Size appears.
6
Press .
7
Press or repeatedly until 4 x 6 in. or 10 x 15 cm appears.
8
Press .
9
Press or repeatedly until Paper Setup appears.
10
Press .
11
Press or repeatedly until Paper Size appears.
12
Press .
13
Press or repeatedly until 10 x 15 cm appears.
14
Press .
15
Press Start Color or Start Black.
Cannot print from digital camera using PictBridge
These are possible solutions. Try one or more of the following:
Enable PictBridge printing from camera
Enable PictBridge printing on the camera by selecting the correct USB mode. For more information, see the digital
camera documentation.
Make sure the camera is a PictBridge-enabled digital camera
1
Disconnect the camera.
2
Connect a PictBridge-enabled digital camera to the PictBridge port. See the digital camera documentation to
determine whether it is PictBridge-enabled.
Check USB cable
Use only the USB cable that came with the camera.
Check messages
If an error message appears on the display, see "Error messages" on page 163.

Copy troubleshooting

Copier does not respond
These are possible solutions. Try one or more of the following:
to clear the error message.
Troubleshooting
153