Travis Industries 564 HO NB GSR2 Installation Manual page 47

Optional Equipment
4. Install the LP pilot orifice following the directions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then
replace the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
a
5. Remove the concealment cover. Unscrew the four screws holding the control cover in place. Carefully remove
the control cover and place face down to access the regulator.
Travis Industries
(
Natural Gas Orifice = .020N (3way)
.018N (2way)
LP (Propane) Orifce = .014LP
7/16" Wrench
4150330
for qualified installers only)
.020N
or
.018N
.014LP
47
b
100-01408