LevelOne WBR-3407 User Manual page 67

WBR-3407 User Guide
Incoming Rules
This screen is displayed when the "Add" or "Edit" button for Incoming Rules is clicked.
Data – Incoming Rules Screen
Inbound Services
Service
Action
Send to
LAN Server
WAN Users
Figure 59: Inbound Services Screen
Select the desired Service. This determines which packets are covered by
this rule. If necessary, you can define a new Service on the "Services"
screen, by defining the protocols and port numbers used by the Service.
Select the desired action for packets covered by this rule:
•
ALLOW always
•
ALLOW by schedule, otherwise Block
•
BLOCK always
•
BLOCK by schedule, otherwise Allow
Note:
•
Any inbound traffic which is not allowed by rules you create will be
blocked by the Default rule.
•
BLOCK rules are only useful if the traffic is already covered by an
ALLOW rule. (That is, you wish to block a sub-set of traffic which
is currently allowed by another rule.)
•
To define the Schedule used in these selections, use the "Schedule"
screen.
Select the PC or Server on your LAN which will receive the inbound
traffic covered by this rule.
These settings determine which packets are covered by the rule, based
on their source (WAN) IP address. Select the desired option:
•
Any - All IP addresses are covered by this rule.
•
Address range - If this option is selected, you must enter the
desired values in the "Single/Start" and "Finish" fields to determine
the address range.
•
Single address - Enter the required address in the "Single/Start"
fields.
64