Table of Contents
Advertisement
REFERENCES
In batch mode, the selected Transmission Mode determines the behavior of the gun
at the time the list of codes is transmitted. If One-way mode is enabled, the codes are
transmitted one after the other without interruption. In Two-way mode, after
transmitting each code, the gun waits for the Host answer message to be shown on
the display. Therefore, in Two-way transmission mode and normal batch mode, the
Start Normal Batch Transmission barcode must be read after each code to
continue, whereas with automatic batch mode just pull and release the trigger after
each code.
The code which has a transmission pending is shown on the display in reverse video
indicating that it cannot be deleted.
5.8.7
Find Me (Dragon M131 only)
If enabled, after a timeout of a few minutes in which Dragon™ M131 is not used, it
enters stand-by mode and its green LED starts blinking in order to signal its location.
5.9
DISPLAY PARAMETERS (SOME M131 MODELS ONLY)
5.9.1
Display Mode
The user can control the gun display behavior according to the following selections:
Normal mode: When a barcode is read with the gun:
•
The code is sent to the Host.
•
The gun display is not cleared. Therefore if any previous data was displayed on
the gun screen it remains.
•
There is no Local Echo to the gun display.
Clear Display After Decode mode: When a barcode is read with the gun:
•
The code is sent to the Host.
•
The gun display is cleared. Therefore if any previous data was displayed on the
gun screen it is cancelled and the screen remains blank.
•
There is no Local Echo of the code to the gun display.
Local Echo mode: When a barcode is read with the gun:
•
The code is sent to the Host.
•
The gun display is cleared.
•
The code is also sent to the gun display (Local Echo).
•
The cursor is positioned after the last printed character on the gun display.
Host messages sent to the gun are always written to the gun display.
5
153
Hide quick links:
Advertisement
Table of Contents
