Status; Table 6: Status Commands - D-Link DWL-8600Ap Reference Manual

D-Link Unified Access Point CLI Reference Manual
Action
Set the password
Set the baud rate for the serial port
Set the system name
Set the system location
Set the administrator's contact information
S
TATUS
Use the commands in this section to view various AP status information.
Note: Make sure you are familiar with the names of the interfaces as described in
on page 11. The interface name you reference in a get command determines whether the command output shows
a wired or wireless interface, the Internal network, or to radio "one" or radio two."
Action
Global command to get all detail on a Basic Service Set (BSS).
This is a useful command to use to get a comprehensive picture of how
the AP is currently configured.
Get information about the wired and WLAN interfaces
Get the MAC Address for the Wired Internal Interface
Get the VLAN ID for the wired interface
Get the Network Name (SSID) for the default virtual access point.
Get the Current IEEE 802.11 Radio Mode
Get the Channel the AP is Currently Using
Get Basic Radio Settings for the Internal Interface
Get Client Associations
Get neighboring access points
Get information about switches that can discover and manage the AP
© 2001- 2009 D-Link Corporation. All Rights Reserved
14
Table 5: Basic Setting Commands (Cont.)
Command
set system password <password>
Example:
set system password test1234
set serial baud-rate
set system system-name <name>
Example:
set system system-name "AEO AP"
set system system-location <location>
set system system-contact <contact_info>

Table 6: Status Commands

"Interface Naming Conventions"
Command
get bss all detail
get interface
get interface wlan0 mac
get management vlan-id
get interface wlan0 ssid
get radio wlan0 mode
get radio wlan0 channel
get radio wlan0
get radio wlan0 detail
get association detail
get detected-ap detail
get managed-ap