Using The Add Command; Using The Remove Command; Additional Cli Commands; Table 2: Additional Cli Commands - D-Link DWL-8600Ap Reference Manual

D-Link Unified Access Point CLI Reference Manual
U
SING THE ADD
The "add" command allows you to add a new instance or group of instances of a class and has the following syntax:
add unique-named-class instance [ property value ... ]
add group-named-class instance [ property value ... ]
add anonymous-class [ property value ... ]
For example:
add mac-acl default mac 00:01:02:03:04:05
Note: If you're adding an instance to a unique-named class, you must assign the instance a name not already in
use by any other instance of that class. If you add instances to group-named classes, you can form groups by
creating instances and assigning them identical names. All instances of a group-named class that have the same
name form a group of instances.
U
SING THE REMOVE
The "remove" command allows you to remove an existing instance of a class and has the following syntax:
remove unnamed-class [ property value . . . ]
remove named-class instance | all [ property value . . .]
For example:
remove mac-acl default mac 00:01:02:03:04:05
A CLI C
DDITIONAL
The CLI also includes the following commands for maintenance tasks:
Command
save-running
reboot
factory-reset
firmware-upgrade
config
For information about classes, instances, and properties, see
© 2001- 2009 D-Link Corporation. All Rights Reserved
8
C
OMMAND
C
OMMAND
OMMANDS

Table 2: Additional CLI Commands

Description
The command saves the running configuration as the startup configuration.
save-running
For more information, see
The reboot command restarts the access point (a "soft" reboot).
The factory-reset
Use the firmware-upgrade
Use the command to upload or download the AP configuration file.
config
"Saving Configuration Changes" on page
command resets the AP to factory defaults and reboots.
command to upload a new AP image.
"CLI Classes and Properties Reference" on page
12.
20.