Dmx Protocol; Thermal Performance - Chroma Color One 100 User Manual

5-Reset
To reset the Color One 100 to the factory default settings,
1. From the Main Menu, press Up Up Up Up or Down
2. Press Enter
3. Press and hold Enter
back to the Main Menu.
All control menu commands are reset to factory defaults:
DMX address
Personality
No DMX Present
Look Store
PWM Frequency

2.6 DMX Protocol

DMX Personality:
Color One Color One 100 Color One Color One 100 100 100 1-RGBA
V1.5 5 5 5 V1. [4 ch]
V1. V1.
Channel 1 Red
Channel 2 Green
Channel 3 Blue
Channel 4 Amber
Channel 5
Total 4 DMX ch

2.7 Thermal Performance

The internal cooling system of the Color One 100 is by convection. When the internal temperature exceeds 75 º C, the output
of the fixture is reduced for automatic protection. This happens on rare and extreme conditions when ambient temperature is
over 35 º C.
3. Troubleshooting
Troubleshooting is a process of elimination. First, rule out the other field factors (i.e. bad connections, faulty cables and
power supplies). For technical support and/or parts, please contact your selling dealer or the offices listed in this manual.
Symptom
Fixture does not respond
to DMX control.
Low LED output.
Color One 100 User Manual
Enter, display shows reset?
Enter Enter
Enter for 2 seconds, display shows Hold for 2 sec. and Done after 2 seconds, then
Enter Enter
1
RGBA
Hold Last
1
750Hz
2-RGBAI
[5 ch]
Red
Green
Blue
Amber
Intensity
5 DMX ch
Possible Cause
Set to wrong or different DMX address.
Bad cable connecting DMX control and fixture.
Bad in/through connection between adjacent
fixtures.
Internal temperature is over the limit.
www.chroma-q.com
Down Down to access 5-Reset Down
3-HSI 4-RGB
[3 ch]
[3 ch]
Amber
Hue Red
Saturation Green
Intensity Blue
3 DMX ch 3 DMX ch
13
5-MLED RGB
*Magic
[3 ch]
Red
Green
Blue
3 DMX ch
Solution
Check DMX address and Mode
settings.
Check/replace DMX run from the
console.
Check area ventilation.
V1.3 July 2015