Operation - HomeMatic HM-LC-Sw1-Pl-DN-R4 Operating Manual

Start-up
box shows how much teach-in time remains.
• Meanwhile, please activate the teach-in mode of your switch actua-
tor to teach-in as well. Therefore, press and hold the channel but-
ton (A) for at least 4 seconds. The device LED (B) will flash slowly
to indicate that teach-in mode is active.
• After a short time, the newly taught-in device will appear in the in-
box of your software interface. The button „Inbox (x new devices)"
indicates how many new devices have been taught-in successfully.
• If required, you can teach-in additional devices by repeating the
steps described above for each device.
• Now configure the newly taught-in devices in the inbox as de-
scribed in section „Configuring newly taught-in devices" .
Configuring newly taught-in devices
Once you have taught-in your switch actuator to the HomeMatic Cen-
tral Control Unit, it will be moved to the inbox. Here, you must configure
the device and its associated channels in order to make them avail-
able for operating and configuration tasks. Give the device a name
and assign the device/channels to a room. You can individually adjust
the switch on and off duration of the device as well as a delay time for
switching connected devices on and off.
30
> 4 s
Now you can use the „WebUI" user interface to control your device,
configure it, connect it directly to other devices, or use it in central con-
trol unit programs. Please refer to the HomeMatic WebUI Manual for
more details (you can find this in the „Downloads" area of the website
www.homematic.com).
6

Operation

After teaching-in and configuring the device, you can control the switch
actuator e.g. with a connected remote control to switch on and off con-
nected loads (see the following fig.).
Lights off
Operation
Lights on
31