Restore Factory Settings; Error Codes And Device Led Feedback; Flash Codes; Operational Status Display - HomeMatic HM-LC-Sw1-Pl-DN-R4 Operating Manual

Restore factory settings

7 Restore factory settings
The factory settings of the switch actuator can be restored manually. If
you do this, you will lose all your settings.
To restore the factory settings, please proceed as follows:
• Press and hold down the channel button (A) for at least four
seconds until the device LED (B) will slowly start flashing.
• Release the button again.
• Press and hold down the channel button (A) again for at least 4
seconds until the device LED (B) will quickly start flashing.
• Release the button again.
• The device LED stops flashing.
• The factory settings of the device are now restored.
32
> 4 s
8

Error codes and device LED feedback

8.1

Flash codes

Various actuator states are indicated by the device LED (B):
Flashing sequence Meaning
Slow flashing Teach-in mode
activated or stage
before restoring the
factory settings
Fast flashing The factory settings
of the device will be
restored.
1 x long, 1 x short Transmit limit (duty
flashing cycle) reached
1 x long, 2 x short Device defective
flashing
8.2

Operational status display

The device LED (B) lights up permanently as soon as the switch actua-
tor is switched on.
After configuring the switch actuator with the Central Control Unit or
a programming tool, the device LED indicates other device states be-
sides those described (e.g. switch on and off delay or duration).
8.3

Duty cycle

The duty cycle is a legally regulated limit of the transmission time of
devices in the 868 MHz range. The aim of this regulation is to safe-
guard the operation of all devices working in the 868 MHz range.
In the 868 MHz frequency range we use, the maximum transmission
time of any device is 1% of an hour (i.e. 36 seconds in an hour). De-
vices must cease transmission when they reach the 1% limit until this
time restriction comes to an end. HomeMatic devices are designed and
Error codes and device LED feedback
Solution
/
/
please see sec. „8.3 Duty
cycle" on page 33
Please contact your
specialist dealer.
33