Install The Servos And Pushrods - GREAT PLANES F1 Rocket Evo Instruction Manual

❏
2.Install the 5/32 x 1-1/4" [32mm] axle into the landing gear
and secure it with the 5/16-24 [7.9mm] nut. Do this for both
landing gear legs. Position the fl at spot as shown.
❏
3. Install a 6-32 x 1/8" [3.2mm] set screw into each of the
four 5/32" [4.3mm] wheel collars. Be sure to apply a couple
drops of thread locker to the set screws. Slide a wheel collar
onto the axle followed by the wheel and another wheel collar.
Tighten the set screw against the axle. Be sure the set screw
is tightened against the fl at spot on the end of the axle.
❏
4. Slide the wheel pant over the wheel and secure the
wheel pant to the landing gear with two 2-56 x 3/8" [9.5mm]
screws and two #2 [2mm] fl at washers. Be sure to apply
thread locker to each screw.

Install the Servos and Pushrods

❏
1. Thread a nylon clevis and silicone clevis retainer onto
a 2-56 x 24" [610mm] pushrod 20 complete turns. Install a
silicone clevis keeper onto the clevis. Install the clevis into
the outer hole of the control horn. Slide the wire through the
elevator pushrod exit slot in the right side of the fuselage.
12