Replacement Parts; Performance Data; Operating Requirements - Pentair PENTEK US-1000 Instruction Manual

REPLACEMENT PARTS

1 155832-44 P-250A (Cartridges sold only as a set)
2 153126 White housing
3 151231 O-ring (OR-233)
4 244960 * Lead-Free Faucet
5 143431 Water Supply Adapter
6 150424 Housing Wrench (SW-5)
*image may be different than actual faucet
For replacement parts, contact your nearest PENTEK
distributor or call 800.279.9404.

PERFORMANCE DATA

Important Notice: Read this performance data and compare
the capabilities of this system with your actual water treatment
needs. It is recommended that, before installing a water
treatment system, you have your water supply tested to
determine your actual water treatment needs.
This system has been tested according to NSF/ANSI 42 and 53
for reduction of the substances listed below. The concentration
of the indicated substances in water entering the system
was reduced to a concentration less than or equal to the
permissible limit for water leaving the system, as specified in
NSF/ANSI 42 and 53.
Model US-1000
Influent
Challenge Product Water
Substance Concentration Concentration
Standard 42
Chlorine Taste &
2.0 mg/L±10%
Odor
Particulates** at least 10,000
(0.5–<1µ)-Class I particles/mL
Standard 53
MTBE 0.015 ± 20%
Minimum
Cysts*
50,000/L
10 to 10 fibers/L
7 8
Asbestos > 10 micrometers
in length
Lead (pH 6.5) 0.15 mg/L ± 10%
Lead (pH 8.5) 0.15 mg/L ± 10%
Mercury (pH 6.5) 0.006 mg/L ± 10%
Mercury (pH 8.5) 0.006 mg/L ± 10%
Chloroform
(VOC surrogate 0.304 mg/L ± 10%
chemical)
Flow Rate = 0.5 gpm (1.9 L/min); Capacity = 500 gallons (1893 L) or 6 months
Testing was performed under standard laboratory conditions, actual performance may
vary.
Do not use with water that is microbiologically
WARNING:
unsafe or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst reduction*
may be used on disinfected waters that may contain filterable
cysts.
NOTE: Substances reduced are not necessarily in your water.
Filter must be maintained according to manufacturer's
instructions, including replacement of filter cartridges.
*NSF/ANSI Standard 53 certified to reduce cysts such as
Cryptosporidium and Giardia by mechanical means.
**Reduces particles as small as 0.5-1 micron in size by
mechanical means.
EPA Est. #090375-MEX-001
Maximum
Permissible
Reduction Minimum
Requirements Reduction
≥50%
≥85%
0.005 mg/L 69%
99.95% 99.99%
99% 99.9%
0.010 mg/L 99.3%
0.010 mg/L 99.4%
0.002 mg/L 96.6%
0.002 mg/L 91.1%
0.015 mg/L 97.6%
Test Conditions
Flow Rate
Inlet Pressure
pH
Temperature

Operating Requirements

Pressure
Temperature
Organic Chemicals Included by Surrogate Testing:
Substance
alachor
atrazine
benzene
carbofuran
carbon tetrachloride
chlorobenzene
chloropicrin
2,4-D
dibromochloropropane (DBCP)
o-dichlorobenzene
p-dichlorobenzene
1,2-dichloroethane
1,1-dichloroethylene
cis-1,2-dichloroethylene
trans-1,2-dichloroethylene
1,2-dichloropropane
cis-1,3-dichloropropylene
Average
Reduction
dinoseb
endrin
97%
ethylbenzene
ethylene dibromide (EDB)
99.8%
haloacetonitriles (HAN):
bromochloroacetonitrile
95.9%
dibromoacetonitrile
99.99% dichloroacetonitrile
trichloracetonitrile
99.9% haloketones (HK):
1,1-dichloro-2-propanone
99.3%
1,1,1-trichloro-2-propanone
99.4%
heptachlor
96.6%
heptachlor epoxide
95.5%
hexachlorobutadiene
99.7%
hexachlorocyclopentadiene
lindane
methoxychlor
pentachlorophenol
simazine
styrene
1,1,2,2,-tetrachloroethane
tetrachloroethylene
toluene
2,4,5-TP (silvex)
tribromoacetic acid
1,2,4-trichlorobenzene
1,1,1-trichloroethane
1,1,2-trichloroethane
trichloroethylene
trihalomethanes (includes):
chloroform (surrogate chemical)
bromoform
bromodichloromethane
chlorodibromomethane
xylenes (total)
PENTEK
US-1000 MTBE Filtration System Instruction Manual
®
= as noted for filter system
= 60 psi (4.1 bar)
= 7.5±1
= 68°F ± 5°F (20°C ± 2.5°C)
= 30-125 psi (2.1–8.62 bar)
= 40-100°F (4.4–37.8°C)
Maximum permissible
Influent Challenge product water
Concentration mg/L concentration mg/L
0.050 0.001
0.100 0.003
0.081 0.001
0.190 0.001
0.078 0.0018
0.077 0.001
0.015 0.0002
0.110 0.0017
0.052 0.00002
0.080 0.001
0.040 0.001
0.088 0.0048
0.083 0.001
0.170 0.0005
0.086 0.001
0.080 0.001
0.079 0.001
0.170 0.0002
0.053 0.00059
0.088 0.001
0.044 0.00002
0.022 0.0005
0.024 0.0006
0.0096 0.0002
0.015 0.0003
0.0072 0.0001
0.0082 0.0003
0.25 0.00001
0.0107 0.0002
0.044 0.001
0.060 0.000002
0.055 0.00001
0.050 0.0001
0.096 0.001
0.120 0.004
0.150 0.0005
0.081 0.001
0.081 0.001
0.078 0.001
0.270 0.0016
0.042 0.001
0.160 0.0005
0.084 0.0046
0.150 0.0005
0.180 0.0010
0.300 0.015
0.070 0.001
• 9