Entering The Adjustment Mode; Key Assignments For The Adjustment Mode; Frequency Adjustment - Icom IC-2300H Service Manual Addendum

5-1 PREPARATION (continued)

ENTERING THE ADJUSTMENT MODE

1) Turn OFF the power.
2) Connect the JIG cable (See page 6-1) to the microphone connector.
[SET] and [MONI]
3) While holding down
Push to turn ON the power.
MW
VOL
S.MW
SQL
Connect the JIG cable (See page 6-1) here.

KEY ASSIGNMENTS FOR THE ADJUSTMENT MODE

Stores the value for the item
MW
VOL
S.MW
SQL
QUITTING THE ADJUSTMENT MODE
1) Turn OFF the power.
2) Disconnect the JIG cable, and then turn ON the power.

5-2 FREQUENCY ADJUSTMENT

1) Select an adjustment item using [BANK] or [V/MHz].
2) Set or modify the adjustment value as specifi ed using [DIAL], and then push [S.MW].
TRANSCEIVER'S
ADJUSTMENT
REFERENCE 1 • Transmitting
FREQUENCY
*: For [USA]
, turn ON the power.
[SET] [MONI]
TX power Adjustment frequency
MUTE
NAR
MID
LOW
LOCK ANM
S ET
MONI
CONDITION
1) Connect a power meter or dummy load
to the antenna connector.
2) Loosely couple a frequency counter to
the antenna connector.
3) While transmitting, adjust the frequency
using [DIAL], and then push [S.MW] to
store the adjustment value.
Adjustment item
DIGITAL PRIO AO BUSY
T - SCAN
DUP PRIO SCAN
LOW TONE M/CALL V/ MHz
Selects the previous adjustment item
OPERATION
5 - 2
BANK OPT
Adjusts the value for the item
BANK OPT
Selects the next adjustment item
(without storing value)
ADJUSTMENT
VALUE
ITEM
145.000000 MHz
(146.000000 MHz*)
(±100 Hz)
[ ]